3 Vásárlói vélemény magyar nyelven: Creality Ender 3 V2 Neo
6 vásárlói vélemény más nyelven
4,6 az 5 csillagból
5 csillag | | 12 | (80%) |
---|---|---|---|
4 csillag | | 2 | (13%) |
3 csillag | | 0 | (0%) |
2 csillag | | 0 | (0%) |
1 csillag | | 1 | (6%) |
Értékelések szűrése:
-
-
Ender 3 V2 Neo
5 csillaggal5értékelt.
It is my first printer, and after leveling it correctly, the printer does a wonderul job with Cura. I am using it less than a week, but printed already about 600-700 g of PLA. Very good one, I absolutely recommend this printer
Ez az értékelés hasznos volt az Ön számára? (9) (0)
-
Vélemény
5 csillaggal5értékelt.
Nagyon meg vagyok elégedve a termékkel.
Ez az értékelés hasznos volt az Ön számára? (7) (2)
Magazinunkból:
3DJake felfedezése:
-
Magyarország: Ingyenes kiszállítás 20.000 Ft-tól
-
Ingyenes
visszaküldés -
24 órás kiszállítás
Több, mint 9.150 termék
Perfect printer for beginners and enthusiasts
5 csillaggal5értékelt.
The printer came in a well prepared box. You can see so many unpacking videos over the internet. The beauty of this printer is in it's simplicity. It is not overcomplicated but stable and roboust as it should be. The bed leveling is a bit tricky first time, but if you make levelling after first heat up and keeping the bed warm, your leveling will be perfect. Keep in mind that these printers not tolerate relocations... If you move your printer to another desk or just moving it around, you might need to recalibrate the bed. However, it is easy to do after the first calibration. (I mean, proper calibration) The Z axis pole must be greased and unfortunately it is not in the package. You might see some inaccuracy until you apply some grease on that. (You can see videos about that as well...)
Pros:
- fast and accurate printing
- user friendly
- not overcomplicated
- roboust design
- easy to assemble
- all required tools provided
- SD card with USB to micro SD adapter is in the pack with Creality Slicer on it.
- really silent printing
- simple printing onboard software
- pause, stop and restart printing (even in case of power loss)
- Optionally you can buy a leaser cutter / engraver head for it.
Cons:
- levelling is a bit tricky
- moving it on the desk requires re-calibration
- retratction must be user configured to avoid printing issues
- head cooler is a bit noisy, but you can replace it with maglev one
Ez az értékelés hasznos volt az Ön számára? (3) (0)